mechanical seal pump seal pump parts

• Shaft protection over the entire seal length
• Protection of the seal face during installation due to special bellows design
• Insensitive to shaft deflections due to large axial movement ability
• Universal application opportunities
• important material certifications available
• High flexibility due to wide offer on materials
• Suitable for low-end sterile applications
• Special design for hot water pumps (RMG12) available
• Dimension adaptions and additional seats available

Recommended applications

• Water and waste water technology
• Food and beverage industry
• Pulp and paper industry
• Chemical industry

• Water, waste water, slurries
• Pulp
• Latex
• Dairies, beverages
• Sulfide slurries
• Chemicals
• Oils

• Chemical standard pumps
• Helical screw pumps
• Stock pumps
• Circulating pumps
• Submersible pumps
• Water and waster water pumps
• Oil applications

Prifile:

1.Single seal
2.Unbalanced
3.Independent of direction of rotation
4.Elastomer bellows

( the MG series )are the most commonly used. The bellows is not subjected to any torsional stress and its ingenious design incorporates several functions, as seal face carrier, secondary sealing element and drive collar. The seal face is driven through the spring and L-rings. There are no bonded joints and all the face materials are inter-changeable without having to modify any dimensions. Highly recommended for duties with media containing solids eg.in waste water and sewage applications.

Operating Limits:

Specification: 10~110mm

Pressure: ≤1.2Mpa

Temperature: -20oC~120oC

Linear speed: ≤10m/s

Axial movement: ±0.5mm

Combination of materials:

Sealing face: graphite, silicon carbide, tungsten carbide, aluminum oxide

Secondary sealing: acrylonitrile rubber, fluorine rubber, ethylene propylene rubber

metal component: SS316